ULTRA - Adjustable Ball Joint - Set Up Tool

This handy tool makes for setting the lash on the ULTRA adjustable ball joints more effortless. Simply remove the retainer ring and use this tool to set the pre-load on the stud plate. Machined to it fits over the grease zerk.

Ball Joint Adjustment steps:
1. Using a 3/32" allen wrench. loosen up the two set screws
2. Put the tool into the upper hex hole over the grease zerk
3. Turn the adjuster tool clockwise until its tight
4. Back it off slightly until the ball joint stud rotates smoothly
5. Line up the washer to desired location within the slots

* Be sure to grease them before use*